Guides · RO water purifier
Some reject-water flow is part of RO operation. Continuous flow after the expected stop point needs a model-specific assessment. Observe whether the storage tank fills and whether the noise or reject flow stops at any point.
Start here
The purifier keeps running or discharging reject water after the tank should have filled.
Some reject-water flow is part of RO operation. Continuous flow after the expected stop point needs a model-specific assessment.
A model-specific approach
Check tank level detection, automatic shut-off, inlet valve, pressure controls and the purification flow path.
The exact model and operating conditions determine which tests apply. These are possible inspection directions, not a list of components that must be changed.
Observe whether the storage tank fills and whether the noise or reject flow stops at any point.
Record the timing, previous work and accessible model label. Do not remove covers or handle live, refrigerant or pressurised components to obtain information.
Completion
Verify both the filling cycle and automatic stop rather than judging only the first water produced.
Discuss which operation was checked and what to observe during normal use. Keep the service date, model and work description if you need to report the symptom again.
Related information
10 questions for this page
The purifier keeps running or discharging reject water after the tank should have filled. Note when it begins and whether another function still works.
Some reject-water flow is part of RO operation. Continuous flow after the expected stop point needs a model-specific assessment. Compare that explanation with the actual operating conditions before describing the symptom as a failed component.
Check tank level detection, automatic shut-off, inlet valve, pressure controls and the purification flow path. Internal electrical, pressurised and refrigerant work should be handled by a suitable technician.
Observe whether the storage tank fills and whether the noise or reject flow stops at any point. Keep those observations with the model number so the technician can reproduce the reported conditions.
Verify both the filling cycle and automatic stop rather than judging only the first water produced. Use these observations to describe progress; do not treat one short run as proof that an intermittent issue has ended.
No. This guide explains the inspection route; it cannot establish a component diagnosis remotely. Some reject-water flow is part of RO operation. Continuous flow after the expected stop point needs a model-specific assessment.
Use the full RO water purifier model code, not just the brand. Check tank level detection, automatic shut-off, inlet valve, pressure controls and the purification flow path.
Stop if there is smoke, a burning smell, dangerous movement or water near electrical parts. Isolate supplies only if safe. Observe whether the storage tank fills and whether the noise or reject flow stops at any point.
Yes. Record from a safe position without removing covers. The purifier keeps running or discharging reject water after the tank should have filled. Capture that behaviour if it occurs naturally.
Send the model, symptom, locality and preferred time within 8 AM–8 PM to 9342652963. Observe whether the storage tank fills and whether the noise or reject flow stops at any point.
Let’s take the next step
Tell us the appliance, the problem and your locality.